• Begin a floating floor installation with the male of long side against the wall!
• Leave expansion space at all walls and all vertical obstructions, e.g. (fireplace, doorjambs, etc.)

Step One - First Row

Use the starter row as an alignment guide, leave space in between planks.
The numbers of planks use should correspond to the size of the space.
You may remove the starter row when the third row is completed.
Shift the floors toward the wall against the spacers and proceed the installation.

Step Two - Subsequent Rows

2-1. Start each subsequent row with cut off end of last board from previous row.
Such cut off piece must be longer than 30.5cm.
Beginning at left, stagger end joints by minimum 15.25cm (20.32cm is preferred).

2-2. Procedure for installing each board: Set cut-off board from previous row, as described in Step 2.1.
Remember to allow for expansion gap and shim accordingly. Work from left to right.

2-3. At end of row, cut board to appropriate length (allowing for expansion gap)

After Installation

For more information, including pre-installation, job-site requirements and warranty information please click here